Fits all older Simpson, Westinghouse & Kelvinator dryers made by either Email or Electrolux in Australia including MaxiDry, Sirocco, early EziSet, except large commercial models and the very latest models. Fits Whirlpool models made by Email. Suits models with 30mm (approx) horizontal slots at either end of the dryer back panel. Note some Sirocco models can only be mounted upside down.
Not suitable for older Whirlpool WED series dryer models, or for very old Westinghouse models made in Japan by National Panasonic. Not suitable for some newer model Westinghouse dryers including models LD352 & LD353 which actually use the Hoover style bracket listed here. Also not suitable for the newest style front vented Simpson Eziset, EziLoader, Westinghouse & Electrolux dryers which use the bracket listed here.
This part does not come with fitting instructions. We also have the genuine Hoover bracket similar to this one but with instructions listed here.
If you are unsure of suitability, contact us with your full model number prior to purchasing (usually located behind the door).
Mounting bracket plus spacers to hold dryer level away from the wall. Mounting hardware such as wood screws, dynabolts, loxins, etc are not included as the actual hardware required will depend on the type of wall the bracket is attached to.
If mounting to a plaster wall it is important to make sure the bracket is affixed securely to the upright wall studs either directly or via a horizontal piece of timber screwed to the studs. Instructions are not supplied with the item, but help can be provided by email or phone if required after purchasing.
